UPM-2XP Loa nguồn điểm 5" đôi Meyer Sound
Tính năng nổi bật
ACOUSTICAL1 |
|||
Operating Frequency Range2 |
80 Hz – 20 kHz |
||
Frequency Response3 |
85 Hz – 19 kHz ±4 dB |
||
Phase Response |
300 Hz – 18 kHz ±60 degrees |
||
Linear Peak SPL4 |
123 dB with 18 dB crest factor (M-noise), 120 dB (Pink noise), 120.5 dB (B‑noise) |
||
COVERAGE |
|||
Horizontal Coverage |
45° |
||
Vertical Coverage |
45° |
||
TRANSDUCERS |
|||
Low Frequency |
Two 5‑inch cone drivers; 8 Ω nominal impedance |
||
High Frequency |
One 1‑inch metal dome tweeter; 8 Ω nominal impedance |
||
AUDIO INPUT |
|||
Type |
Differential, electronically balanced |
||
Maximum Common Mode Range |
±15 V DC, clamped to earth for voltage transient protection |
||
Connectors |
Phoenix 5‑pin Male; SwitchCraft 5‑pin Male; ECO‑M 7‑pin Male (two pins for 48 V DC power, three pins for balanced audio) |
||
Input Impedance |
10 kΩ differential between positive (+) and negative (‑) audio pins |
||
Wiring5 |
Phoenix 5‑pin Male Pin 1: DC Power (‑) Pin 2: DC Power (+) Pin 3: Chassis/earth through 1 kΩ, 1000 pF, 15 V clamp network to provide virtual ground lift at audio frequencies Pin 4: Audio (‑) Pin 5: Audio (+) |
SwitchCraft EN3 5‑pin Male Pin 1: DC Power (‑) Pin 2: DC Power (+) Pin 3: Chassis/earth through 1 kΩ, 1000 pF, 15 V clamp network to provide virtual ground lift at audio frequencies Pin 4: Audio (‑) Pin 5: Audio (+) |
ECO‑M 7‑pin Male5 Pin 1: DC Power (‑) Pin 2: DC Power (+) Pin S: Chassis/earth through 1 kΩ, 1000 pF, 15 V clamp network to provide virtual ground lift at audio frequencies Pin 5: Audio (‑) Pin 6: Audio (+) |
Nominal Input Sensitivity |
–8.0 dBV (0.4 V rms) continuous average is typically the onset of limiting for noise and music |
||
Input Level |
Audio source must be capable of producing of +20 dBV (10 V rms) into 600 Ω to produce the maximum peak SPL over the operating bandwidth of the loudspeaker. |
||
AMPLIFIER |
|||
Type |
3‑channel, Class‑D |
||
Total Output Power6 |
650 W peak |
||
THD, IM, TIM |
< 0.02% |
||
Cooling |
Convection |
||
DC POWER |
|||
Connector |
Phoenix 5‑pin Male; SwitchCraft 5‑pin Male; ECO‑M 7‑pin Male (two pins for 48 V DC power, three pins for balanced audio) |
||
Safety Rated Voltage Range |
48 V DC |
||
RMS NETWORK (OPTIONAL) |
|||
|
Equipped with two‑conductor twisted‑pair network, reporting all operating parameters of amplifiers to system operator’s host computer. |